Removal 1. Turn ignition switch OFF and disconnect the negative (-) battery cable. • Disconnect the battery negative cable and wait for at least thirty seconds before beginning work.
Troubleshooting Symptom Possible cause Countermeasure Wind noise around the door Arise the gap on weatherstrip Replace weatherstrip Water leaks from panorama sunroof Miss install of panorama sunroof frame weather strip and deforming Replace seal breakage Fill with sealant Wind noise on Panorama Sunroof Deflector deformation and deviation Replace or Remounting Noise while panorama sunroof is working (noise when opening or closing) Accumulation on the guide rail or rear rail Clean guide rail/rear rail and apply grease Tilt lever shoe excessive wear and breakage Replace tilt lever shoe Panorama Sunroof malfunction (Motor work, sunroof move partially or does not move Accumulation on the guide rail or rear rail 1.
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the mode control actuator connector. 3. Verify that the mode control actuator operates to the defrost mode when connecting 12V to terminal 3 and grounding terminal 7.
Description • PDW consists of 8 sensors (front : 4 units, rear : 4 units) that are used to detect obstacles and transmit the result in three separate warning levels, the first, second and third to IBU via LIN communication.