Hyundai Santa Fe (TM): Interior Trim / Rear Pillar Trim. Repair procedures

Hyundai Santa Fe (TM) 2019-2023 Service and Repair Manual / Body (Interior and Exterior) / Interior Trim / Rear Pillar Trim. Repair procedures

Replacement
  
•
Put on gloves to prevent hand injuries.
  
•
When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
•
When removing the interior trim pieces, use a plastic panel removal tool not to damage the surface.
•
Take care not to bend or scratch the trim and panels.
•
Once the rear pillar trim is removed, be sure to replace the clips with new ones.
1.
Remove the luggage side trim.
(Refer to Interior Trim - "Luggage Side Trim")
2.
After loosening the mounting bolt and remove the second row seat belt upper anchor (A).
3.
After loosening the mounting bolts, remove the rear pillar trim (A).
4.
To install, reverse removal procedure.
  
•
Replace any damaged clips (or pin-type retainers).
•
Once the front pillar trim is removed, be sure to replace the clip (B) with new ones.

    Component Location 1. Rear Pillar Trim

    Other information:

    Hyundai Santa Fe (TM) 2019-2023 Service and Repair Manual: Rear Evaporator Core. Repair procedures

    Replacement 1. Remove the rear heater & A/C unit. (Refer to Rear Heater - "Rear Heater Unit") 2. Loosen the mounting screws and remove the rear A/C lower case (A).

    Hyundai Santa Fe (TM) 2019-2023 Service and Repair Manual: Heater & A/C Control Unit (Rear). Repair procedures

    Replacement    • When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.

    Categories

     
    Copyright © 2025 www.hsafe4.com - 0.0109