Hyundai Santa Fe: Rear Bumper / Rear Bumper beam Assembly. Components and components location

1. Rear Bumper
Beam Assembly
|
|
Replacement
•
Put on gloves to prevent hand injuries...
Replacement
•
Put on gloves to prevent hand injuries...
Other information:
System display and control
You can see the status of the Highway Driving Assist operation in the Driving
Assist mode on the cluster. Refer to “LCD Display Modes” section in chapter 4. Highway
Driving Assist will be displayed as below depending on the status of the system...
When the engine stops automatically by ISG, the engine will restart if one of
the following is done.
- Release the brake pedal.
- When Auto Hold is activated, take your foot off the brake pedal and then depress
the accelerator pedal.
- While depressing the brake pedal, shift the gear from N (Neutral) or D (Drive)
to R (Reverse) or P (Park)...
Categories
WARNING
To reduce the risk of an air bag deploying unexpectedly and causing serious
injury or death:
Do not hit or allow any objects to impact the locations where air
bags or sensors are installed.
Do not perform maintenance on or around the air bag sensors. If
the location or angle of the sensors is altered, the air bags may deploy when
they should not or may not deploy when they should.
Installing bumper guards with nongenuine Hyundai or non-equivalent
parts may adversely affect the collision and airbag deployment performance.
Press the Engine Start/Stop button to the OFF or ACC position and
wait for 3 minutes when the vehicle is being towed to prevent inadvertent air
bag deployment.
Have all air bag repairs performed by an authorized HYUNDAI dealer.
read more