Hyundai Santa Fe: Front Seat / Front Seat Cushion Cover. Repair procedures

Hyundai Santa Fe (TM) 2019-2025 Service Manual / Body (Interior and Exterior) / Front Seat / Front Seat Cushion Cover. Repair procedures

Replacement

•	Put on gloves to prevent hand injuries.

•	When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.

•	Use a plastic panel removal tool to remove interior trim pieces without marring the surface.

•	Take care not to bend or scratch the trim and panels.

1.	Remove the front seat assembly. (Refer to Front Seat - "Front Seat Assembly")

2.	Remove the front seat shield outer cover. (Refer to Front Seat - "Front Seat Outer Cover")

3.	Remove the front seat shield inner cover. (Refer to Front Seat - "Front Seat Inner Cover")

4.	Remove the front seat lower protector (A).

5.	Remove the protector (A) from the front seat cushion frame. [Lower] [Upper] [LH] [RH]

6.	Press the lock pin and separate the front seat heater connector (A).

7.	Remove the front seat cushion cover (A) from the front seat cushion frame.

8.	After removing the Velcro tape (A) inside the front seat cushion cover, remove the seat cushion cover (B).

9.	To install, reverse removal procedure.

Front Seat Cushion Cover. Components and components location

Front Seat Frame Assembly. Components and components location

Other information:

Hyundai Santa Fe (TM) 2019-2025 Service Manual: Air Cleaner. Repair procedures

Removal and Installation Air Cleaner Assembly 1. Disconnect the battery negative terminal. 2. Remove the engine cover. (Refer to Engine And Transaxle Assembly - “Engine Cover”) 3...

Hyundai Santa Fe (TM) 2019-2025 Service Manual: Description and operation

Description The ignition coil is mounted on the top side of the cylinder head cover end. The ignition coil consists of the primary coil that receives battery power and the secondary coil that generates high voltage. When the current in the primary coil is cut off by the ignition signal of the ECM, the rapid change of the magnetic flux by the mutual induction action is induced to the secondary coil and high voltage is generated depending on the coil winding ratio...