Hyundai Santa Fe: Rear Door / Rear Door Outside Handle. Repair procedures
1. |
Remove the plug hole and loosen the mounting bolt, remove the rear door
outside handle (A).
Tightening torque :
7.8 - 10.8 N.m (0.8 - 1.1 kgf.m, 5.8 - 8.0 lb-ft)
|

|
2. |
To install, reverse removal procedure.
• |
Make sure the door locks / unlocks and opens / closes
properly.
|
• |
Be sure to install the outside handle pad (A) between
the outside handle and the door panel.

|
|
|
Other information:
Adjustment
1.
After loosening the hinge (A) mounting bolt, adjust the hood (B) by
moving it up and down or from side to side and tighten the bolt.
2.
Adjust the hood height by moving the hood overslam bumpers (C) up and
down...
Replacement
•
Be careful not to damage the parts located under the vehicle
(floor under cover, fuel filter, fuel tank and canister) when
raising the vehicle using the lift...
Categories
Engine oil pressure warning light
.png)
This warning light illuminates:
When the engine oil pressure is low.
If the engine oil pressure is low:
1. Drive carefully to the nearest safe location and stop your vehicle.
2. Turn the engine off and check the engine oil level (For more details, refer
to “Engine Oil” section in chapter 9). If the level is low, add oil as required.
read more