Hyundai Santa Fe: Body Side Molding / Side Sill Molding. Repair procedures

Hyundai Santa Fe (TM) 2019-2025 Service Manual / Body (Interior and Exterior) / Body Side Molding / Side Sill Molding. Repair procedures

Replacement

•	Put on gloves to prevent hand injuries.

•	When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.

•	Take care not to scratch the body surface.

1.	Using a remover, remove the side sill molding (A).

To install, reverse removal procedure.

•	Replace any damaged clips (or pin-type retainers).

Quarter Garnish. Repair procedures

Replacement • Put on gloves to prevent hand injuries...

Roof Side Molding. Repair procedures

Replacement • Put on gloves to prevent hand injuries...

Other information:

Hyundai Santa Fe (TM) 2019-2025 Owner's Manual: Check tire pressure

You can check the tire pressure in the Warning mode on the cluster. Refer to the “LCD Display Modes” in chapter 4. Tire pressure is displayed after a few minutes of driving after initial engine start up. If tire pressure is not displayed when the vehicle is stopped, “Drive to display” message will appear...

Hyundai Santa Fe (TM) 2019-2025 Owner's Manual: Owner maintenance schedule

When you stop for fuel: Check the engine oil level. Check the coolant level in the engine coolant reservoir or the water-cooled intercooler coolant reservoir. Check the windshield washer fluid level. Check for low or under-inflated tires. WARNING Be careful when checking your coolant level when the engine is hot...