Hyundai Santa Fe (TM): Mirror / Outside Rear View Mirror. Repair procedures

Replacement
  
•
Put on gloves to prevent hand injuries.
  
•
When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
•
Take care not to scratch the body surface.
1.
Remove the front door trim.
(Refer to Front door - "Front Door Trim")
2.
Using a screwdriver or remover, remove the outside rear view mirror inner cover (A).

3.
Press the lock pin, separate the outside rear view mirror connector (A).

4.
Loosen the mounting nuts and clip, remove the outside rear view mirror (A).
Tightening torque :
6.9 - 10.8 N.m (0.7 - 1.1kgf.m , 5.1 - 8.0 lb-ft)

5.
To install, reverse removal procedure.
  
•
Make sure the connector is connected properly.

    Component Location 1. Outside Rear View Mirror

    Component Location 1. Inside Rear View Mirror

    Other information:

    Hyundai Santa Fe (TM) 2019-2023 Service and Repair Manual: Rear Blower Motor. Repair procedures

    Replacement 1. Disconnect the negative (-) battery terminal. 2. Remove the luggage side trim [RH]. (Refer to Body - "Luggage Side Trim") 3. Separate the blower motor connector (A) and loosen the mounting screws and remove the

    Hyundai Santa Fe (TM) 2019-2023 Service and Repair Manual: Heater & A/C Control Unit (Manual). Components and components location

    Categories

     
    Copyright © 2025 www.hsafe4.com - 0.014