Hyundai Santa Fe: Front Seat / Front Seat Assembly. Repair procedures

Hyundai Santa Fe (TM) 2019-2025 Service Manual / Body (Interior and Exterior) / Front Seat / Front Seat Assembly. Repair procedures

Replacement
1.
Open the cover and loosen the front seat mounting bolts.
[Front]
Tightening torque :
44.1 - 58.8 N.m (4.5 - 6.0 kgf.m , 32.5 - 43.4 lb-ft)

[Rear]

2.
Separate the main connector (A) , side airbag connector (B) , front seat belt buckle connector (C) and OCS connector (D).
[Driver's]

[Passenger's]

3.
To install, reverse removal procedure.
  
The installation procedures of seat mounting bolts
Push the seat to the rear end of slides and initially tighten the front mounting bolts.
Push the seat to the front end of slides and completely tighten the rear mounting bolts.
Send the seat to the rear end again to completely tighten the front mounting bolts.
Check the seat for smooth movement.
For the non-automatic slide seats, check the seats are fixed at each designated fixing position.

    Front Seat Assembly. Components and components location

    ..

    Front Seat Shield Outer Cover. Components and components location

    ..

    Other information:

    Hyundai Santa Fe (TM) 2019-2025 Owner's Manual: System operation


    Warning and control Lane Following Assist If the vehicle ahead and/or both lane markings are detected and your vehicle speed is below 110 mph (180 km/h), the green indicator light will illuminate on the cluster, and the system will help center the vehicle in the lane by assisting the steering wheel...

    Hyundai Santa Fe (TM) 2019-2025 Service Manual: Description and operation


    Description and Operation Blcok Diagram    • This system monitors the driving situations through the radar and the camera...

    Categories

    Gauges and meters

    Speedometer

    The speedometer indicates the speed of the vehicle and is calibrated in miles per hour (MPH) and/or kilometers per hour (km/h).

    Tachometer

    read more


     
    Copyright © 2025 www.hsafe4.com