Hyundai Santa Fe (TM): Rear Door / Rear Door Frame Molding. Repair procedures

Hyundai Santa Fe (TM) 2019-2023 Service and Repair Manual / Body (Interior and Exterior) / Rear Door / Rear Door Frame Molding. Repair procedures

Replacement
  
•
Put on gloves to prevent hand injuries.
  
•
When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
•
Be careful not to scratch the door trim and other parts.
1.
Using a remover and remove the rear door frame molding (A).
2.
To install, reverse removal procedure.
  
•
Replace any damaged clips (or pin-type retainers).
•
If any parts are damaged after removing the door frame molding, replace it with a new one.

    Replacement    • Put on gloves to prevent hand injuries.

    Other information:

    Hyundai Santa Fe (TM) 2019-2023 Service and Repair Manual: Temperature Control Actuator. Components and components location

    Hyundai Santa Fe (TM) 2019-2023 Service and Repair Manual: Power Mosfet (DATC). Repair procedures

    Inspection 1. Turn the ignition switch ON. 2. Manually operate the control switch and measure the voltage of the blower motor. 3. Select the control switch to raise the voltage until high speed.

    Categories

     
    Copyright © 2025 www.hsafe4.com - 0.0201