Hyundai Santa Fe: Rear Seat Belt / Rear Seat Belt Buckle. Repair procedures

Hyundai Santa Fe (TM) 2019-2025 Service Manual / Body (Interior and Exterior) / Rear Seat Belt / Rear Seat Belt Buckle. Repair procedures

Replacement
[Second row seat belt buckle]
  
•
Be sure to remove the second row center seat belt buckle (A) and the second row seat assembly [RH] (B) after removing the second row seat assembly [LH / RH].
1)
Second row seat assembly [LH] is positioned at the rearside, and second row seat assembly [RH] is positioned at the frontside.
2)
Loosen the mounting bolt (C) and remove the second row center seat belt buckle and the second row seat assembly [LH].
[Center]
1.
Remove the second row seat assembly [RH].
(Refer to Rear Seat -"Rear Seat Assembly")
2.
Loosen the mounting nut and remove the second row seat belt buckle (A).
Tightening torque :
39.2 - 53.9 N.m (4.0 - 5.5 kgf.m , 28.9 - 39.8 lb-ft)

3.
To install, reverse removal procedure.
[RH]
1.
Remove the second row seat assembly [RH].
(Refer to Rear Seat -"Rear Seat Assembly")
2.
Loosen the mounting screw and remove the rear seat inner cover (A).
3.
Loosen the mounting bolt and remove the second row seat belt buckle [RH] (A)
Tightening torque :
39.2 - 53.9 N.m (4.0 - 5.5 kgf.m , 28.9 - 39.8 lb-ft)

4.
To install, reverse removal procedure.
  
•
The buckle and tongue of different types are impossible to be latched, so check that the buckle & tongue have the same types.
•
Distinguish the rear side seat buckle from the center seat buckle before latching.
•
If foreign materials are stuck in the inside button of buckle, it may cause interference during the latching process, leading to a functional problem (for example- beverages (viscous drinks), toothpicks, sand, plastic, vinyl, metal pieces, etc.).
•
After latching the buckle and tongue, check the fastening force using a Push-Pull Gauge (fastening force : 3kgf or less)
[Third row seat belt buckle]
1.
Remove the third row seat assembly [RH].
2.
Loosen the mounting bolt and remove the third row seat belt buckle [LH] (A).
Tightening torque :
39.2 - 53.9 N.m (4.0 - 5.5 kgf.m , 28.9 - 39.8 lb-ft)

3.
To install, reverse removal procedure.

    Rear Seat Belt Buckle. Components and components location

    Component Location [Second row seat belt buckle] 1. Second row seat belt buckle [LH] 2. Second row center seat belt buckle 3...

    Body Electrical System

    ..

    Other information:

    Hyundai Santa Fe (TM) 2019-2025 Owner's Manual: Limitations of the system


    Reverse Parking Collision-Avoidance Assist may not assist braking or warn the driver even if there are pedestrians or objects under the following circumstances: Any non-factory equipment or accessory is installed Your vehicle is unstable due to an accident or other causes Bumper height or rear ultrasonic sensor installation has been modified Rear view camera or rear ultrasonic sensor(s) is damaged Rear view camera or the rear ultrasonic sensor(s) is stained with foreign material, such as snow, dirt, etc...

    Hyundai Santa Fe (TM) 2019-2025 Owner's Manual: Electric Power Steering (EPS) warning light. Charging system warning light


    Electric Power Steering (EPS) warning light This warning light illuminates: When you set the ignition switch or the Engine Start/Stop button to the ON position. - The electric power steering warning light illuminates for about 3 seconds and then goes off...

    Categories

    Air bag - supplemental restraint system

    1. Driver’s front air bag
    2. Passenger’s front air bag
    3. Side air bag
    4. Curtain air bag

    The vehicles are equipped with a Supplemental Air Bag System for the driver’s seat and front passenger’s seats.

    The front air bags are designed to supplement the three-point seat belts. For these air bags to provide protection, the seat belts must be worn at all times when driving.

    read more


     
    Copyright © 2025 www.hsafe4.com