Hyundai Santa Fe: Front End Module / Front Bumper Beam Assembly. Repair procedures
•
|
Put on gloves to prevent hand injuries.
|
•
|
When removing with a flat-tip screwdriver or remover, wrap protective
tape around the tools to prevent damage to components.
|
•
|
Use a plastic panel removal tool to remove interior trim pieces
without marring the surface.
|
•
|
Take care not to bend or scratch the trim and panels.
|
|
1. |
Disconnect the battery (-) terminal.
|
2. |
Remove the front bumper assembly.
(Refer to Front Bumper - "Front Bumper Assembly")
|
3. |
Remove the front radar unit.
(Refer to Advanced Driver Assistance System (ADAS) - "Front Radar Unit")
|
4. |
Disconnect the connector (A) and then remove the ambient temperature
sensor (B).

|
5. |
Loosen the bolts, nuts and remove the front bumper beam assembly (A).

|
6. |
To install, reverse removal procedure.
|
Other information:
Inspection
1.
Check the signal waveform of the CMPS and CKPS using the diagnostic
tool.
Specification : Refer to "DTC Diagnostic Guide"
Removal
•
Be careful not to damage the parts located under the vehicle
(floor under cover, fuel filter, fuel tank and canister) when
raising the vehicle using the lift...
Component Location
1. Lumber support
motor (Vertical)
2. Lumbar support motor (Horizontal)
3. Reclining motor
4. Rear height motor
5. Front height motor
6. Slide motor
7. Power seat switch
8. Reclining switch
9...
Categories

1. Instrument cluster
2. Driver’s front air bag
3. Engine Start/Stop button
4. Infotainment system
5. Hazard warning lamp switch
6. Climate control system
7. Shift button
8. ISG (Idle Stop and Go) button
9. Auto Hold button
10. Heated steering wheel button
11. Drive mode button
12. DBC (Downhill Brake Control) button
13. Parking Safety button
14. Parking/View button
15. Air ventilation seat button
16. Seat warmer
17. Passenger’s front air bag
18. Glove box
19. Wireless charging system pad
20. Cup holder
21. AC inverter
22. USB charger
read more