Hyundai Santa Fe: Hood / Hood Latch. Repair procedures

Hyundai Santa Fe (TM) 2019-2025 Service Manual / Body (Interior and Exterior) / Hood / Hood Latch. Repair procedures

Replacement

1.	Remove the front bumper assembly. (Refer to Front Bumper - "Front Bumper Assembly")

2.	Press the rock pin to separate the hood latch connector (A) and disconnect wiring clip.

3.	Loosen the mounting bolts and clip from the hood latch (A).

4.	Remove the hood release handle cable (A) from the hood latch (B).

To install, reverse removal procedure.

•	Make sure the hood latch release cable is connected properly.

•	Make sure the hood locks / unlocks and opens / closes properly.

•	Adjust the latch alignment.

•	Replace any damaged clips (or retainers or fasteners).

Hood Latch. Components and components location

Tail Gate

Other information:

Hyundai Santa Fe (TM) 2019-2025 Owner's Manual: Limitations of the system

Reverse Parking Collision-Avoidance Assist may not assist braking or warn the driver even if there are pedestrians or objects under the following circumstances: Any non-factory equipment or accessory is installed Your vehicle is unstable due to an accident or other causes Bumper height or rear ultrasonic sensor installation has been modified Rear view camera or rear ultrasonic sensor(s) is damaged Rear view camera or the rear ultrasonic sensor(s) is stained with foreign material, such as snow, dirt, etc...

Hyundai Santa Fe (TM) 2019-2025 Service Manual: Curtain Airbag (CAB) Module. Repair procedures

Removal 1. Disconnect the battery negative cable and wait for at least 3 minutes before beginning work. 2. Remove the roof trim assembly. (Refer to Body - "Roof Trim Assembly") 3...