Hyundai Santa Fe: Body Side Molding / Front Wheel Guard. Repair procedures
•
|
When removing with a flat-tip screwdriver or remover, wrap protective
tape around the tools to prevent damage to components.
|
•
|
Put on gloves to prevent hand injuries.
|
|
1. |
Remove the front tire.
|
2. |
Loosen the mounting clip,nuts and screws , and remove the front wheel
guard (A).

|
3. |
To install, reverse the removal procedure.
• |
Replace any damaged clips (or pin-type retainers).
|
|
|
Removal
•
When removing with a flat-tip screwdriver or remover, wrap protective
tape around the tools to prevent damage to components...
Replacement
•
When removing with a flat-tip screwdriver or remover, wrap protective
tape around the tools to prevent damage to components...
Other information:
Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Remove the console upper cover (A).
3.
Press the lock pin, separate the console upper cover connectors (A)...
Removal
1.
Turn ignition switch OFF and disconnect the negative (-) battery cable.
2.
Remove the crash pad lower panel.
(Refer to Body - "Crash Pad Lower Panel")
3...
Categories
The front seat can be adjusted by using the control switches located on the outside
of the seat cushion. Before driving, adjust the seat to the proper position so that
you can easily control the steering wheel, foot pedals and controls on the instrument
panel.
WARNING
NEVER allow children in the vehicle unattended. The power seats are operable
when the vehicle is turned off.
read more