Hyundai Santa Fe: Interior Trim / Door Step Trim. Repair procedures

Hyundai Santa Fe (TM) 2019-2025 Service Manual / Body (Interior and Exterior) / Interior Trim / Door Step Trim. Repair procedures

  
Put on gloves to protect your hands.
  
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
Take care not to bend or scratch the trim and panels.
1.
Using a screwdriver or remover and remove the front door step trim (A).
[Front]

[Rear]

2.
To install, reverse removal procedure.
  
Replace any damaged clips.

    Door Step Trim. Components and components location

    ..

    Cowl Side Trim. Components and components location

    ..

    Other information:

    Hyundai Santa Fe (TM) 2019-2025 Service Manual: Transaxle Oil Temperature Sensor. Repair procedures


    Inspection    • Refer to the DTC manual for the check procedure. Removal    • Be careful not to damage the parts located under the vehicle (floor under cover, fuel filter, fuel tank and canister) when raising the vehicle using the lift...

    Hyundai Santa Fe (TM) 2019-2025 Service Manual: Repair procedures


    Replacement    • When removing the fender, wrap protective tape around a screwdriver or remover not to damage components • Put on gloves to prevent hand injuries    • When removing the clips, use a clip remover...

    Categories

    Air bag collision sensors

    WARNING

    To reduce the risk of an air bag deploying unexpectedly and causing serious injury or death:

    Do not hit or allow any objects to impact the locations where air bags or sensors are installed. Do not perform maintenance on or around the air bag sensors. If the location or angle of the sensors is altered, the air bags may deploy when they should not or may not deploy when they should. Installing bumper guards with nongenuine Hyundai or non-equivalent parts may adversely affect the collision and airbag deployment performance. Press the Engine Start/Stop button to the OFF or ACC position and wait for 3 minutes when the vehicle is being towed to prevent inadvertent air bag deployment. Have all air bag repairs performed by an authorized HYUNDAI dealer.

    read more


     
    Copyright © 2025 www.hsafe4.com