Hyundai Santa Fe (TM): Front Bumper / Front Bumper Assembly. Repair procedures

Hyundai Santa Fe (TM) 2019-2023 Service and Repair Manual / Body (Interior and Exterior) / Front Bumper / Front Bumper Assembly. Repair procedures

Replacement
  
•
Put on gloves to prevent hand injuries.
  
•
When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
•
Use a plastic panel removal tool to remove interior trim pieces without marring the surface.
•
Take care not to bend or scratch the trim and panels.
1.
Loosen the front bumper upper mounting clips.
2.
Loosen the front bumper lower mounting clips.
3.
Loosen the mounting clis and screws on the side of front bumper (A), detach the side part of front bumper.
  
•
When you pull out the front bumper, the side part of the front bumper could be damaged by the projection.

4.
Press the lock pin and separate the front bumper main connector (A).
5.
Remove the front bumper assembly (A).
6.
To install, reverse removal procedure.
  
•
Make sure the connector is plugged in properly.
•
Replace any damaged clips (or pin-type retainers).

    Component Location 1. Front Bumper Assembly

    Component Location 1. Radiator Grill

    Other information:

    Hyundai Santa Fe (TM) 2019-2023 Service and Repair Manual: Front Radar Unit. Specifications

    Hyundai Santa Fe (TM) 2019-2023 Service and Repair Manual: Description and operation

    Description Surround View Monitor (SVM) is the system that allows video monitoring of 360 degrees around the vehicle. The system includes 4 ultra optical camera mounted around the vehicle (front, both sides, rear). The video from these cameras are applied with distortion compensation, time point conversion, and video me

    Categories

     
    Copyright © 2025 www.hsafe4.com - 0.0222