Hyundai Santa Fe: Body Side Molding / Rear Wheel Guard. Repair procedures

Hyundai Santa Fe (TM) 2019-2025 Service Manual / Body (Interior and Exterior) / Body Side Molding / Rear Wheel Guard. Repair procedures

Replacement

•	When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.

•	Put on gloves to prevent hand injuries.

1.	Remove the rear tire.

2.	Loosen the mounting clip and remove the rear wheel guard (A).

To install, reverse the removal procedure.

•	Replace any damaged clips (or pin-type retainers).

Front Wheel Guard. Repair procedures

Replacement • When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components...

Door Garnish. Repair procedures

Replacement • When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components...

Other information:

Hyundai Santa Fe (TM) 2019-2025 Service Manual: Blower Motor. Repair procedures

Inspection 1. Connect the battery voltage and check the blower motor rotation. 2. If the blower motor does not operate well, substitute with a known-good blower motor and check for proper operation...

Hyundai Santa Fe (TM) 2019-2025 Owner's Manual: If you decide to pull a trailer?

Here are some important points if you decide to pull a trailer: Consider using a sway control. You can ask a trailer hitch dealer about sway control. Do not do any towing with your vehicle during its first 1,200 miles (2,000 km) in order to allow the engine to properly break in...