Hyundai Santa Fe (TM): Rear Seat Belt / Rear Center Seat Belt Retractor. Repair procedures

Hyundai Santa Fe (TM) 2019-2023 Service and Repair Manual / Body (Interior and Exterior) / Rear Seat Belt / Rear Center Seat Belt Retractor. Repair procedures

Replacement
  
•
When installing the belt, make sure not to damage the retractor.
1.
Remove the second row seat back cover[LH].
(Refer to Rear Seat -"Rear Seat Back Cover")
2.
Loosen the rear center seat belt lower anchor mounting bolt (A) at the bottom of the second row seat cushion [LH].
Tightening torque :
39.2 - 53.9 N.m (4.0 - 5.5 kgf.m , 28.9 - 39.8 lb-ft)

3.
Loosen the mounting nut and remove the rear center seat belt retractor (A).
Tightening torque :
39.2 - 53.9 N.m (4.0 - 5.5 kgf.m , 28.9 - 39.8 lb-ft)

4.
To install, reverse removal procedure.
  
•
Replace any damaged clips.

    Component Location 1. Rear center seat belt retractor

    Component Location [Second row seat belt buckle] 1. Second row seat belt buckle [LH] 2. Second row center seat belt buckle 3.

    Other information:

    Hyundai Santa Fe (TM) 2019-2023 Service and Repair Manual: PTC Heater (Diesel only). Repair procedures

    Inspection Operating Logic Test (Manual only) Inspect the PTC operation with the confirmation logic below : 1. Entering (1) Set the mode to FLOOR. (2) Set the temperature to MAX HOT.

    Hyundai Santa Fe (TM) 2019-2023 Service and Repair Manual: Description and operation

    Description • PDW consists of 8 sensors (front : 4 units, rear : 4 units) that are used to detect obstacles and transmit the result in three separate warning levels, the first, second and third to IBU via LIN communication.

    Categories

     
    Copyright © 2025 www.hsafe4.com - 0.0185