Hyundai Santa Fe (TM): Rear Door / Rear Door Module. Repair procedures

Hyundai Santa Fe (TM) 2019-2023 Service and Repair Manual / Body (Interior and Exterior) / Rear Door / Rear Door Module. Repair procedures

Replacement
1.
Remove the rear door window glass.
(Refer to Rear Door - "Rear Door Window Glass")
2.
Remove the rear door outside handle.
(Refer to Rear Door - "Rear Door Outside Handle")
3.
Press the lock pin and separate the rear door main connector (A).
4.
Loosen the rear door out side handle base mounting screw (A).
5.
Loosen the rear door latch mounting screw (A).
Tightening torque :
7.8 - 10.8 N.m (0.8 - 1.1 kgf.m, 5.8 - 8.0 lb-ft)

6.
Remove the rear door channel (A).
7.
Loosen mounting bolts and remove the rear door module (A).
Tightening torque :
8.8 - 13.7 N.m (0.9 - 1.4 kgf.m, 6.5 - 10.1 lb-ft)

8.
Remove the rear door main wiring (A).
9.
To install, reverse removal procedure.
  
•
Make sure connectors are connected properly and each rod is connected securely.
•
Make sure the door locks / unlocks and opens / closes properly.

    Component Location 1. Rear Door Module

    Component Location 1. Rear Door Outside Handle

    Other information:

    Hyundai Santa Fe (TM) 2019-2023 Service and Repair Manual: Temperature Control Actuator. Description and operation

    Description The heater unit includes mode control actuator and temperature control actuator. The temperature control actuator is located at the heater unit. It regulates the temperature by the procedure as follows. Signal from control unit adjusts the position of the temperature door by operating the temperature switch

    Hyundai Santa Fe (TM) 2019-2023 Service and Repair Manual: Surround View Monitor (SVM) Camera. Components and components location

    Categories

     
    Copyright © 2025 www.hsafe4.com - 0.0097