Hyundai Santa Fe (TM): Body (Interior and Exterior) / Floor Carpet. Repair procedures

Hyundai Santa Fe (TM) 2019-2023 Service and Repair Manual / Body (Interior and Exterior) / Floor Carpet. Repair procedures

Repair procedures

Replacement
  
•
Put on gloves to prevent hand injuries.
  
•
When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
•
Use a plastic panel removal tool to remove interior trim pieces without marring the surface.
•
Take care not to bend or scratch the trim and panels.
1.
Remove the front seat assembly.
(Refer to Front Seat - "Front Seat Assembly")
2.
Remove the rear seat cushion assembly.
(Refer to Rear Seat - "Rear Seat Assembly")
3.
Remove the floor console assembly.
(Refer to Floor Console - "Floor Console Assembly")
4.
Remove the cowl side trim.
(Refer to Interior Trim - "Cowl Side Trim")
5.
Remove the center pillar lower trim.
(Refer to Interior Trim - "Center Pillar Trim")
6.
Remove the accelerator pedal module.
(Refer to Fuel system-"accelerator pedal")
7.
Remove the front floor carpet assembly (A) , and rear floor carpet assembly (B).
8.
To install, reverse removal procedure.
  
•
Replace any damaged clips (or pin-type retainers).

1. Floor Floor Carpet Assembly
 2. Rear Floor Carpet Assembly

    Components and components location Components 1. Quarter Fixed Glass Repair procedures Replacement [Removal]    • Put on gloves to prevent hand injuries.

    Front Bumper Beam Assembly. Components and components location Components Location 1. Front bumper beam assembly Front Bumper Beam Assembly.

    Other information:

    Hyundai Santa Fe (TM) 2019-2023 Service and Repair Manual: Indicators And Gauges

    Troubleshooting Troubleshooting Symptom Possible cause Remedy Speedometer does not operate Cluster fuse (10A) blown Check for short and replace fuse Speedometer faulty Check speedometer CAN line faulty

    Hyundai Santa Fe (TM) 2019-2023 Service and Repair Manual: In-car Sensor. Description and operation

    Description The In-car air temperature sensor is built in the heater & A/C control unit. The sensor consists of a thermistor that measures the inside temperature. The signal decided by the resistance value that changes in accordance with perceived inside temperature, is delivered to heater control unit, and according t

    Categories

     
    Copyright © 2026 www.hsafe4.com - 0.0191