Hyundai Santa Fe: Tail Gate / Tail Gate Assembly. Repair procedures

Hyundai Santa Fe (TM) 2019-2025 Service Manual / Body (Interior and Exterior) / Tail Gate / Tail Gate Assembly. Repair procedures

Replacement
  
•
Wear gloves to protect hands from injury.
  
•
When removing and installing the tailgate, an assistant is needed.
1.
Remove the tailgate trim.
(Refer to Tailgate - "Liftgate Trim")
2.
Using a screwdriver, lift the socket clips (A) up slightly on both ends of the tailgate lifter (B).
3.
Disconnect the connectors and tailgate wiring harness (A).
4.
After loosening the mounting bolts, then remove the tailgate assembly (B).
Tightening torque :
21.6 - 26.5 N.m (2.2 - 2.7 kgf.m, 15.9 - 19.5 lb-ft)

5.
To install, reverse removal procedure.
  
•
Make sure the tailgate locks / unlocks and opens / closes properly.
•
Adjust the tailgate alignment.
•
Make sure the connectors are connected in properly.
•
Replace any damaged clips (or pin-type retainers).

    Tail Gate Assembly. Components and components location

    ..

    Tail Gate Trim. Components and components location

    ..

    Other information:

    Hyundai Santa Fe (TM) 2019-2025 Service Manual: Components and components location


    Components [5 seat vehicle] 1. Luggage side trim [LH] 2. Luggage side trim [RH] 3. Rear transverse trim 4. Cargo screen 5. Luggage floor tray 6. Luggage board 7. Luggage met 8. Luggage floor box rear trim 9...

    Hyundai Santa Fe (TM) 2019-2025 Service Manual: Specifications


    ..

    Categories

    Armrest

    The armrest is located in the center of the rear seat. Pull the armrest down from the seatback to use it.

    read more


     
    Copyright © 2025 www.hsafe4.com