Hyundai Santa Fe: Interior Trim / Cowl Side Trim. Repair procedures
•
|
Put on gloves to prevent hand injuries.
|
|
•
|
When removing with a flat-tip screwdriver or remover, wrap protective
tape around the tools to prevent damage to components.
|
•
|
When removing the interior trim pieces, use a plastic panel
removal tool not to damage the surface.
|
•
|
Take care not to bend or scratch the trim and panels.
|
|
1. |
Remove the front door scuff trim.
(Refer to Interior Trim - "Door Scuff Trim")
|
2. |
Remove the hood latch release handle.
(Refer to Hood - "Hood Latch Release Handle")
|
3. |
Carefully remove the front door body side weatherstrip.
|
4. |
Using a screwdriver or remover, remove the cowl side trim (A).

|
5. |
To install, reverse removal procedure.
• |
Replace any damaged clips (or pin-type retainers).
|
|
|
Other information:
If your vehicle comes with roof side rails, then roof side rails crossbars can
be installed on top of your vehicle.
The roof side rails crossbars are an accessory and are available at your HYUNDAI
dealer.
NOTICE
If the vehicle is equipped with a sunroof, be sure not to position cargo onto
the roof side rails in such a way that it could interfere with sunroof operation...
..
Categories
Electric Power Steering (EPS) warning light
.png)
This warning light illuminates:
When you set the ignition switch or the Engine Start/Stop button to
the ON position.
- The electric power steering warning light illuminates for about 3 seconds
and then goes off.
Whenever there is a malfunction with the electric power steering.
If this occurs, have the vehicle inspected by an authorized HYUNDAI dealer.
read more