Hyundai Santa Fe: Trunk Trim / Luggage Side Trim. Repair procedures

Hyundai Santa Fe (TM) 2019-2025 Service Manual / Body (Interior and Exterior) / Trunk Trim / Luggage Side Trim. Repair procedures

Replacement

•	Put on gloves to prevent hand injuries.

•	When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.

•	When removing the interior trim pieces, use a plastic panel removal tool not to damage the surface.

•	Take care not to bend or scratch the trim and panels.

1.	Remove the third row seat assembly. (Refer to Rear Seat - "Rear Seat Assembly")

2.	Remove the rear door body side weatherstrip. (Refer to Rear DooR -"Rear Door Body Side Weatherstrip")

3.	Remove the tailgate weatherstrip. (Refer To Tailgate -"Tailgate Weatherstrip")

4.	Remove the rear door scuff trim. (Refer to Interior Trim -"Door Scuff Trim")

5.	Remove the Rear transverse trim. (Refer to Interior Trim -"Rear Transverse Trim")

6.	Push the second row seat towards the front of the vehicle as far as possible.

7.	Remove the cover (A) and loosen the mounting bolt and remove the second row seat belt lower anchor (B).

8.	Loosen the mounting bolt and remove the third row seat belt lower anchor (A).

9.	Loosen the mounting screws and remove the luggage side trim (A).

10.	Press the lock pin and separate the various connector (A).

11.

To install, reverse removal procedure.

•	Replace any damaged clips (or pin-type retainers).

Rear Transverse Trim. Repair procedures

Replacement • Put on gloves to prevent hand injuries...

Windshield Glass

Other information:

Hyundai Santa Fe (TM) 2019-2025 Service Manual: Rear Seat Frame Assembly. Components and components location

Component Location [Second row seat assembly] (LH) 1. Rear seat back frame assembly 2. Rear seat cushion frame assembly (RH) 1. Rear seat back frame assembly 2...

Hyundai Santa Fe (TM) 2019-2025 Service Manual: Immobilizer Control Unit. Repair procedures

Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the glove box housing. (Refer to Body - "Glove Box Housing Cover") 3. Disconnect the connector (A) and then remove the IBU (B) after loosening a nut...