Hyundai Santa Fe: Controller / Heater & A/C Control Unit (Rear). Repair procedures
•
|
When removing with a flat-tip screwdriver or remover, wrap protective
tape around the tools to prevent damage to components.
|
•
|
Put on gloves to prevent hand injuries.
|
|
•
|
Take care not to bend or scratch the trim and panels.
|
|
1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the luggage side trim [RH].
(Refer to Body - "Luggage Side Trim")
|
3. |
Loosen the mountig screws and then remove the rear heater & A/C control
unit (A).

|
4. |
To install, reverse removal procedure.
• |
Replace any damaged clips (or pin-type retainers).
|
• |
Make sure the connector are connected in properly.
|
|
|
Other information:
Description
The primary purpose of the SRSCM (Supplemental Restraints System Control Module)
is to discriminate between an event that warrants restraint system deployment
and an event that does not. The SRSCM must decide whether to deploy the restraint
system or not...
..
Categories
Electric Power Steering (EPS) warning light
.png)
This warning light illuminates:
When you set the ignition switch or the Engine Start/Stop button to
the ON position.
- The electric power steering warning light illuminates for about 3 seconds
and then goes off.
Whenever there is a malfunction with the electric power steering.
If this occurs, have the vehicle inspected by an authorized HYUNDAI dealer.
read more