Hyundai Santa Fe (TM): Body (Interior and Exterior) / Fuel Filler Door

Hyundai Santa Fe (TM) 2019-2023 Service and Repair Manual / Body (Interior and Exterior) / Fuel Filler Door

Components and components location

Component Location

1. Fuel Filler Door

Repair procedures

Replacement

•	Put on gloves to prevent hand injuries.

•	When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.

1.	Open the fuel filler door (A).

2.	Remove the luggage side trim. (Refer to interior trim - "Luggage Side Trim")

3.	Loosen the mounting nuts and remove the luggage cover (A).

4.	Separate to fuel filler door cable (B) from fuel door actuator (A).

5.	Separate to fuel filler door cable (A).

6.	Using a screwdriver or remover, remove the fuel filler door (A).

To install, reverse removal procedure.

•	Make sure the fuel filler door locks/unlocks and opens/closes properly.

•	Replace any damaged clips (or pin-type retainers).

❮Tail Gate

Repair procedures Adjustment 1. Place the car on a flat surface and check whether the body and trunk lid are well-aligned.

Front Door❯

Components and components location Components 1. Front door window glass 2. Front door window glass run assembly 3.

Other information:

Hyundai Santa Fe (TM) 2019-2023 Service and Repair Manual: Photo Sensor. Repair procedures

Inspection 1. Emit intensive light toward the photo sensor using a lamp, and check the output voltage change. 2. The voltage will rise with higher intensive light and reduce with lower intensive light.

Hyundai Santa Fe (TM) 2019-2023 Service and Repair Manual: Special service tools