Hyundai Santa Fe: Front Door / Front Door Frame Garnish. Repair procedures
•
|
Put on gloves to prevent hand injuries.
|
|
•
|
When removing with a flat-tip screwdriver or remover, wrap protective
tape around the tools to prevent damage to components.
|
•
|
Be careful not to scratch the door trim and other parts.
|
|
1. |
Remove the front door belt outside weatherstrip.
(Refer to Front Door - "Front Door Outside Weatherstrip")
|
2. |
Using a remover and remove the front door frame garnish (A).

|
3. |
To install, reverse removal procedure.
• |
Replace any damaged clips (or pin-type retainers).
|
• |
If any parts are damaged after removing the door frame
garnish, replace it with a new one.
|
|
|
Replacement
[Front door side weatherstrip]
1.
Loosen the front door checker (B) mounting bolt.
Tightening torque :
21...
Replacement
•
Put on gloves to prevent hand injuries...
Other information:
Fuel Pressure Test
1.
Release the residual pressure in fuel line.
(Refer to Delivery System - "Release Residual Pressure in Fuel Line")
•
When removing the fuel pump fuse, a Diagnostic Trouble
Code (DTC) may occur...
Operating button
Press the Parking/View button (1) to turn on Surround View Monitor. Press
the button again to turn off the system.
Other view modes can be selected by touching the view icons (2) on the
Surround View Monitor screen.
When one of the infotainment system button (3) is pressed without the
gear in R (Reverse), Surround View Monitor will turn off...
Categories
The front seat can be adjusted by using the control switches located on the outside
of the seat cushion. Before driving, adjust the seat to the proper position so that
you can easily control the steering wheel, foot pedals and controls on the instrument
panel.
WARNING
NEVER allow children in the vehicle unattended. The power seats are operable
when the vehicle is turned off.
read more