Hyundai Santa Fe: Front Door / Front Door Frame Molding. Repair procedures
•
|
Put on gloves to prevent hand injuries.
|
|
•
|
When removing with a flat-tip screwdriver or remover, wrap protective
tape around the tools to prevent damage to components.
|
•
|
Be careful not to scratch the door trim and other parts.
|
|
1. |
Using a remover and remove the front door frame molding (A).

|
2. |
To install, reverse removal procedure.
• |
Replace any damaged clips (or pin-type retainers).
|
• |
If any parts are damaged after removing the door frame
molding, replace it with a new one.
|
|
|
Replacement
•
Put on gloves to prevent hand injuries...
Other information:
We recommend that the engine oil and filter be changed by an authorized HYUNDAI
dealer according to the Maintenance Schedule at the beginning of this chapter.
WARNING
CALIFORNIA PROPOSITION 65 WARNING
Engine oil contains chemicals known to the State of California to cause cancer,
birth defects and reproductive harm...
Lane Keeping Assist is designed to help detect lane markings (or road edges)
while driving over a certain speed. The system will warn the driver if the vehicle
leaves the lane without using the turn signal, or will automatically assist the
driver’s steering to help prevent the vehicle from departing the lane...
Categories

1. Driver’s front air bag
2. Passenger’s front air bag
3. Side air bag
4. Curtain air bag
The vehicles are equipped with a Supplemental Air Bag System for the driver’s
seat and front passenger’s seats.
The front air bags are designed to supplement the three-point seat belts. For
these air bags to provide protection, the seat belts must be worn at all times when
driving.
read more