Hyundai Santa Fe: Rear Door / Rear Door Inside Handle. Repair procedures
1. |
Remove the rear door trim.
(Refer to Rear Door - "Rear Door Trim")
|
2. |
After loosening the mounting screws, remove the rear door inside handle
(A).

|
3. |
To install, reverse removal procedure.
• |
Make sure the door locks / unlocks and opens / closes
properly.
|
• |
Replace any damaged clips (or pin-type retainers).
|
|
|
Replacement
•
Put on gloves to prevent hand injuries...
Other information:
Inspection
1.
Check the signal waveform of the CMPS and CKPS using the diagnostic
tool.
Specification : Refer to "DTC Diagnostic Guide"
Removal
•
DON’T remove the camshaft position sensor during engine running
or right after engine stops, or a scald by the flowed out engine
oil may occur...
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the license lamp lens (A) from the panel after loosening a screw.
3.
Replace the bulb (B) after removing the license lamp (A)...
Categories
Vehicle Identification Number (VIN)

The vehicle identification number (VIN) is the number used in registering your
vehicle and in all legal matters pertaining to its ownership, etc.
The number is punched on the floor under the passenger seat. To check the number,
open the cover.
read more