Hyundai Santa Fe (TM): Body Side Molding / Door Garnish. Repair procedures

Hyundai Santa Fe (TM) 2019-2023 Service and Repair Manual / Body (Interior and Exterior) / Body Side Molding / Door Garnish. Repair procedures

Replacement
  
•
When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
•
Put on gloves to prevent hand injuries.
1.
Using a remover or screwdriver and remove the front door garnish (A) and rear door garnish (B).
2.
To install, reverse the removal procedure.
  
•
Replace any damaged clips (or pin-type retainers).

    Replacement    • When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.

    Other information:

    Hyundai Santa Fe (TM) 2019-2023 Service and Repair Manual: Intake Actuator. Repair procedures

    Inspection 1. Turn the ignition switch OFF. 2. Disconnect the intake actuator connector. 3. Verify that the intake actuator operates to the fresh air position when connecting 12V to terminal 3 and grounding terminal 7.

    Hyundai Santa Fe (TM) 2019-2023 Service and Repair Manual: Ultrasonic Sensor. Repair procedures

    Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the front/rear bumper. (Refer to Body - "Front Bumper Cover") (Refer to Body - "Rear Bumper Cover") 3.

    Categories

     
    Copyright © 2025 www.hsafe4.com - 0.0174