Hyundai Santa Fe: Body Side Molding / Quarter Garnish. Repair procedures
| •
|
Put on gloves to prevent hand injuries.
|
|
| •
|
When removing with a flat-tip screwdriver or remover, wrap protective
tape around the tools to prevent damage to components.
|
| •
|
Take care not to scratch the body surface.
|
|
|
1. |
Using a screwdriver or remover, remove the quarter garnish (A).
|
|
2. |
To install, reverse removal procedure.
|
• |
Replace any damaged clips (or pin-type retainers).
|
|
|
Replacement
•
Put on gloves to prevent hand injuries...
Replacement
•
Put on gloves to prevent hand injuries...
Other information:
1. Move the lever (1) either to the L (left side) or R (right side) to select
the side view mirror you would like to adjust.
2. Use the mirror adjustment control (2) to position the selected mirror up,
down, left or right.
3. After adjustment, move the lever (1) to the middle to prevent inadvertent
adjustment...
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the HO2S connector.
3.
Measure resistance between the HO2S terminals 4 and 5 [B1/S1] [Euro-V]...
Categories
The armrest is located in the center of the rear seat. Pull the armrest down
from the seatback to use it.
read more
Fender Garnish. Repair procedures
Side Sill Molding. Repair procedures