Hyundai Santa Fe: Front Seat Belt / Front Seat Belt Pretensioner. Repair procedures

Hyundai Santa Fe (TM) 2019-2025 Service Manual / Body (Interior and Exterior) / Front Seat Belt / Front Seat Belt Pretensioner. Repair procedures

Replacement

•	When installing the belt, make sure not to damage the pretensioner.

1.	Remove the front anchor seat belt (A).

2.	Remove the center pillar lower trim. (Refer to Interior Trim - "Center Pillar Trim")

3.	Remove the center pillar upper trim. (Refer to Interior Trim - "Center Pillar Trim")

Loosen the mounting bolt and remove the front seat belt upper anchor (A).

Tightening torque :

39.2 - 53.9 N.m (4.0 - 5.5 kgf.m , 28.9 - 39.8 lb-ft)

5.	Press the lock pin and separate the front seat belt pretensioner connector (A).

Loosen the mounting bolt and remove the front seat belt pretensioner (A).

Tightening torque :

Bolt B : 7.8 - 11.8 N.m (0.8 - 1.2 kgf.m , 5.8 - 8.7 lb-ft)

Bolt C : 39.2 - 53.9 N.m (4.0 - 5.5 kgf.m , 28.9 - 39.8 lb-ft)

To install, reverse removal procedure.

•	When installing the connector, be sure to insert it to the anchor pretensioner until "click" sound is heard and then check it for secure installation by pulling it.

•	After installing the front seat belt retractor, check that the air bag warning indicator illuminates for about 6 seconds when the ignition is ON and then goes out.

•	Make sure the connector is plugged in properly.

•	Replace any damaged clips (or pin-type retainers).

Front Seat Belt Pretensioner. Components and components location

Height Adjust. Components and components location

Other information:

Hyundai Santa Fe (TM) 2019-2025 Owner's Manual: Jump starting

Jump starting can be dangerous if done incorrectly. Follow the jump starting procedure in this section to avoid serious injury or damage to your vehicle. If in doubt about how to properly jump start your vehicle, we strongly recommend that you have a service technician or towing service do it for you...

Hyundai Santa Fe (TM) 2019-2025 Owner's Manual: Hood

Opening the hood 1. Park the vehicle and set the parking brake. 2. Pull the release lever to unlatch the hood. The hood should pop open slightly. 3. Go to the front of the vehicle, raise the hood slightly, push up the secondary latch (1) inside of the hood center and lift the hood...