Hyundai Santa Fe: Front Door / Front Door Latch. Repair procedures

Hyundai Santa Fe (TM) 2019-2025 Service Manual / Body (Interior and Exterior) / Front Door / Front Door Latch. Repair procedures

Replacement

1.	Remove the front door module. (Refer to Front Door - "Front Door Module")

2.	Remove the front door inside handle case (A).

3.	Press the lock pin and separate connector (A).

4.	Remove the front door latch (A) from the module (B) by pushing it in the direction of the arrow.

5.	Remove the front door outside handle base connector (A).

6.	Separate the wiring harness (A) from the top of the front door out side handle base.

7.	Remove the front door outside handle base braket (A).

8.	Loosen the front door outside handle rod (A) and remove the front door outside handle base (B).

To install, reverse removal procedure.

•	Make sure the connector is connected properly.

•	Make sure the door locks / unlocks and opens / closes properly.

•	Replace any damaged clips (or pin-type retainers).

Front Door Latch. Components and components location

Front Door Belt Outside Weatherstrip. Repair procedures

Replacement 1. Pull down the front door window glass to the lowest level by pressing the power window glass switch...

Other information:

Hyundai Santa Fe (TM) 2019-2025 Owner's Manual: Child-protector rear door locks

The child safety lock is provided to help prevent children seated in the rear from accidentally opening the rear doors. The rear door safety locks should be used whenever children are in the vehicle. The child safety lock is located on the edge of each rear door...

Hyundai Santa Fe (TM) 2019-2025 Service Manual: Description and operation

Description The ignition coil is mounted on the top side of the cylinder head cover end. The ignition coil consists of the primary coil that receives battery power and the secondary coil that generates high voltage. When the current in the primary coil is cut off by the ignition signal of the ECM, the rapid change of the magnetic flux by the mutual induction action is induced to the secondary coil and high voltage is generated depending on the coil winding ratio...