Hyundai Santa Fe: Rear Door / Rear Door Trim. Repair procedures
•
|
Put on gloves to prevent hand injuries.
|
|
•
|
When removing with a flat-tip screwdriver or remover, wrap protective
tape around the tools to prevent damage to components.
|
•
|
Be careful not to scratch the door trim and other parts.
|
|
1. |
Using a flat-tip or remover, remove the rear door pull handle mounting
cap (A).

|
2. |
Using a screwdriver or remover, remove the rear door delta inner cover
(A).

|
3. |
After loosening the mounting screws, remove the rear door trim (A).

|
4. |
Remove the rear door inside handle cage (A).

|
5. |
Disconnect the power window switch connector (A).

|
6. |
To install, reverse removal procedure.
• |
Make sure the connector is connected properly.
|
• |
Make sure the door locks / unlocks and opens / closes
properly.
|
• |
Replace any damaged clips (or pin-type retainers).
|
• |
Make sure the glass moves properly.
|
|
|
Replacement
1.
Remove the rear door trim.
(Refer to Rear Door - "Rear Door Trim")
2...
Other information:
Description
It's a system that uses illumination sensor to automatically turn ON the tail
lamp and head lamp based on the change in surrounding environment's illumination
condition. It activates when the vehicle enters/exits tunnel, or when the illumination
condition in surrounding environment changes due to rain, snow, or fog...
Removal
1.
Remove the front drive shaft.
(Refer to Driveshaft Assembly - "Front Driveshaft")
2.
Remove the trans axle side joint.
(Refer to Driveshaft Assembly - "Transaxl Joint")
3...
Categories
Speedometer
.png)
The speedometer indicates the speed of the vehicle and is calibrated in miles
per hour (MPH) and/or kilometers per hour (km/h).
Tachometer
.png)
read more