Hyundai Santa Fe: Interior Trim / Door Scuff Trim. Repair procedures

Hyundai Santa Fe (TM) 2019-2024 Service Manual / Body (Interior and Exterior) / Interior Trim / Door Scuff Trim. Repair procedures

Replacement

•	Put on gloves to prevent hand injuries.

•	When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.

•	When removing the interior trim pieces, use a plastic panel removal tool not to damage the surface.

•	Take care not to bend or scratch the trim and panels.

[Front]

1.	Remove the front door body side weatherstrip.

2.	Using a screwdriver or remover and remove the front door scuff trim (A).

To install, reverse removal procedure.

•	Replace any damaged clips (or pin-type retainers).

[Rear]

1.	Remove the rear door body side weatherstrip.

2.	Remove the rear seat cusion assembly. (Refer to Rear seat -"Rear Seat Assembly")

3.	Using a screwdriver and remove the rear door scuff trim (A).

To install, reverse removal procedure.

•	Replace any damaged clips (or pin-type retainers).

Door Scuff Trim. Components and components location

Door Step Trim. Components and components location

Other information:

Hyundai Santa Fe (TM) 2019-2024 Service Manual: Automatic Transaxle Fluid (ATF). Components and components location

Hyundai Santa Fe (TM) 2019-2024 Service Manual: In-car Sensor. Description and operation

Description The In-car air temperature sensor is built in the heater & A/C control unit. The sensor consists of a thermistor that measures the inside temperature. The signal decided by the resistance value that changes in accordance with perceived inside temperature, is delivered to heater control unit, and according to this signal, the control unit regulates in-car temperature to intended value...