Hyundai Santa Fe: Rear Door / Rear Door Latch. Repair procedures
1. |
Remove the rear door module.
(Refer to Rear Door - "Rear door module")
|
2. |
Remove the rear door insade handle case (A)

|
3. |
Press the lock pin and separate the connector (A).

|
4. |
Separate the rear door latch (A) from the module (B).

|
5. |
Remove the rear door outside handle base (A).

|
6. |
Separate the rear door outside handle rod (A) and remove the rear door
outside handle base (B).

|
7. |
To install, reverse removal procedure.
• |
Make sure the connector is connected properly.
|
• |
Make sure the door locks / unlocks and opens / closes
properly.
|
• |
Replace any damaged clips (or pin-type retainers).
|
|
|
Replacement
1.
Pull down the rear door window glass to the lowest level by pressing
the power window glass switch...
Other information:
Removal
•
Removal of the airbag must be performed according to the precautions/procedures
described previously.
•
Do not turn the ignition switch ON and do not connect the battery
cable while replacing the side impact sensor...
Front air bags
Front air bags are designed to inflate in a frontal collision depending on the
severity of impact of the front collision.
Side and curtain air bags
Side and curtain air bags are designed to inflate when an impact is detected
by side collision sensors depending on the severity, speed or angles of impact resulting
from a side impact collision...
Categories

The armrest is located in the center of the rear seat. Pull the armrest down
from the seatback to use it.
read more