Hyundai Santa Fe: Body Side Molding / Fender Garnish. Repair procedures
•
|
Put on gloves to prevent hand injuries.
|
|
•
|
When removing with a flat-tip screwdriver or remover, wrap protective
tape around the tools to prevent damage to components.
|
•
|
Take care not to scratch the body surface.
|
|
1. |
Using a screwdriver or remover, remove the fender garnish (A).

|
2. |
To install, reverse removal procedure.
• |
Replace any damaged clips (or pin-type retainers).
|
|
|
Replacement
•
Put on gloves to prevent hand injuries...
Replacement
•
Put on gloves to prevent hand injuries...
Other information:
Removal
1.
Remove the fuel pump.
(Refer to Fuel System - "Fuel Pump")
2.
Disconnect the fuel sender connector (A).
3.
Release the fixing hook (A) and then remove fuel sender (B) in the arrow
direction...
..
Categories
Electric Power Steering (EPS) warning light
.png)
This warning light illuminates:
When you set the ignition switch or the Engine Start/Stop button to
the ON position.
- The electric power steering warning light illuminates for about 3 seconds
and then goes off.
Whenever there is a malfunction with the electric power steering.
If this occurs, have the vehicle inspected by an authorized HYUNDAI dealer.
read more