Hyundai Santa Fe: Hood / Hood Assembly. Repair procedures
•
|
Be careful not to damage the hood and body.
|
|
•
|
Removing or installing the hood requires an assistant.
|
•
|
When removing the clips, use a clip remover.
|
|
1. |
After loosening the hood hinge (A) mounting bolts, remove the hood assembly
(B).
Tightening torque :
21.6 - 26.5 N.m (2.2 - 2.7 kgf.m, 15.9 - 19.5 lb-ft)
|

|
2. |
To install, reverse removal procedure.
• |
Make sure the hood locks / unlocks and opens / closes
properly.
|
• |
Adjust the hood alignment.
|
|
|
Replacement
1.
Using a clip remover, remove the clips and then the hood insulator pad
(A).
•
Be careful not to scratch the hood panel...
Other information:
Description
TPMS Receiver : BCM(body control module) integrated management
1.
Mode
(1)
Virgin State
•
The receiver as a sole part is shipped in this state...
Description
The charging system includes a battery, an alternator with a built-in regulator,
and the charging indicator light and wire.
The Alternator has eight built-in diodes, each rectifying AC current to DC current.
Therefore, DC current appears at alternator "B" terminal...
Categories
Electric Power Steering (EPS) warning light
.png)
This warning light illuminates:
When you set the ignition switch or the Engine Start/Stop button to
the ON position.
- The electric power steering warning light illuminates for about 3 seconds
and then goes off.
Whenever there is a malfunction with the electric power steering.
If this occurs, have the vehicle inspected by an authorized HYUNDAI dealer.
read more