Removal 1. Turn ignition switch OFF and disconnect the negative (-) battery cable. • Disconnect the battery negative cable and wait for at least thirty seconds before beginning work.
Troubleshooting Symptom Possible cause Countermeasure Wind noise around the door Arise the gap on weatherstrip Replace weatherstrip Water leaks from panorama sunroof Miss install of panorama sunroof frame weather strip and deforming Replace seal breakage Fill with sealant Wind noise on Panorama Sunroof Deflector deformation and deviation Replace or Remounting Noise while panorama sunroof is working (noise when opening or closing) Accumulation on the guide rail or rear rail Clean guide rail/rear rail and apply grease Tilt lever shoe excessive wear and breakage Replace tilt lever shoe Panorama Sunroof malfunction (Motor work, sunroof move partially or does not move Accumulation on the guide rail or rear rail 1.
Replacement 1. Using a Lwrench, remove the cap (A) on the bottom of the receiver-drier. 2. Remove the receiver-drier (A) from condenser using a long nose plier. Check for crumbled receiver-drier and clogged bottom cap filter.
Description and operation Description • PDW consists of 8 sensors (front : 4 units, rear : 4 units) that are used to detect obstacles and transmit the result in three separate warning levels, the first, second and third to IBU via LIN communication.