Hyundai Santa Fe (TM): Body (Interior and Exterior) / Special service tools
| Special Service Tools |
|
Tool (Number and name) |
Illustration |
Use |
|
09880 - 4F000 Hog ring clip installer |
|
Hog ring clip installation |
Specifications Items Specification Hood Type Rear hinged, gas lifter type Front Door Construction Front hinged, frame door construction Regulator system Wire drum type Locking system Pin-fork system Rear Door Construction Front hinged, frame door construction Regulator system Wire drum type Locking system Pin-fork system Tail Gate Type Front hinged, gas lifter type Seat Belts Front 3 point type with Emergency Locking Retractor (E.
Components and components location Component Location 1. Fender assembly Repair procedures Replacement • When removing the fender, wrap protective tape around a screwdriver or remover not to damage components • Put on gloves to prevent hand injuries • When removing the clips, use a clip remover.
Other information:
Hyundai Santa Fe (TM) 2019-2023 Service and Repair Manual: Compressor. Repair procedures
Removal 1. If a compressor is available, the air conditioner is operated for a few minutes in the engine idle state and then the engine is stopped. 2. Disconnect the negative (-) battery terminal.
Hyundai Santa Fe (TM) 2019-2023 Service and Repair Manual: Rear Corner Radar System
Description and operation Description Rear Corner Radar is a system that measures the relative speed and distance from the following vehicles by using two electromagnetic wave radar sensors attached to the rear bumper, and detects any vehicle within the blind spot zone and gives off alarm.
Categories
- Manuals Home
- Hyundai Santa Fe Owners Manual
- Hyundai Santa Fe Service Manual
- 4 Wheel Drive (4WD) System
- Engine Mechanical System
- Driving your vehicle
- New on site
- Most important about car
