Hyundai Santa Fe: Driveshaft and axle

Hyundai Santa Fe (TM) 2019-2024 Service Manual / Driveshaft and axle

Repair procedures

Removal 1. Prior to replacing the 4WD ECU, check the 4WD ECU's clutch learing with the diagnostic tool. (Refer to 4WD Control System - "Repair Procedures") 2...

Specifications

Specification Items Inner side Outer side Front driveshaft Joint type HLSJ#104 BJ#104C Max...

Other information:

Hyundai Santa Fe (TM) 2019-2024 Service Manual: Accelerator Position Sensor (APS). Specifications


Specification Accelerator Position Output Voltage (V) [Vref=5V] APS 1 APS 2 C.T 0.7 - 0.8 0.33 - 0.43 W.O.T 3.98 - 4...

Hyundai Santa Fe (TM) 2019-2024 Service Manual: Parking/View Switch. Repair procedures


Removal    • When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components...

Categories

Air bag collision sensors

WARNING

To reduce the risk of an air bag deploying unexpectedly and causing serious injury or death:

Do not hit or allow any objects to impact the locations where air bags or sensors are installed. Do not perform maintenance on or around the air bag sensors. If the location or angle of the sensors is altered, the air bags may deploy when they should not or may not deploy when they should. Installing bumper guards with nongenuine Hyundai or non-equivalent parts may adversely affect the collision and airbag deployment performance. Press the Engine Start/Stop button to the OFF or ACC position and wait for 3 minutes when the vehicle is being towed to prevent inadvertent air bag deployment. Have all air bag repairs performed by an authorized HYUNDAI dealer.

read more


 
Copyright © 2024 www.hsafe4.com