Hyundai Santa Fe: Driveshaft Assembly / Dynamic Damper. Repair procedures

Hyundai Santa Fe (TM) 2019-2024 Service Manual / Driveshaft and axle / Driveshaft Assembly / Dynamic Damper. Repair procedures

Removal

1.	Remove the front drive shaft. (Refer to Driveshaft Assembly - "Front Driveshaft")

2.	Remove the trans axle side joint. (Refer to Driveshaft Assembly - "Transaxl Joint")

Remove the dynamic damper band (A, B) using driver (-).

•	When removing the dynamic damper, lubricate the shaft with soapy water to prevent shaft damage.

4.	Remove the dynamic damper (A).

Installation

Install the dynamic damper (A).

•	When installing the dynamic damper, install it in set with the mounting part (A) of the shaft.

2.	Install the dynamic damper band (A) using SST (09495-39100).

3.	Install the transaxle side joint. (Refer to Driveshaft Assembly - "Transaxl Joint")

4.	Install the front driveshaft. (Refer to Driveshaft Assembly - "Front Driveshaft")

Front Driveshaft. Repair procedures

Removal • Be careful not to damage the parts located under the vehicle (floor under cover, fuel filter, fuel tank and canister) when raising the vehicle using the lift...

Joint Assembly (Transaxle side). Repair procedures

Removal • Drive shaft joints require special grease, so do not add any other type of grease...

Other information:

Hyundai Santa Fe (TM) 2019-2024 Owner's Manual: Auto start

When the engine stops automatically by ISG, the engine will restart if one of the following is done. - Release the brake pedal. - When Auto Hold is activated, take your foot off the brake pedal and then depress the accelerator pedal. - While depressing the brake pedal, shift the gear from N (Neutral) or D (Drive) to R (Reverse) or P (Park)...

Hyundai Santa Fe (TM) 2019-2024 Owner's Manual: Fuses

A vehicle’s electrical system is protected from electrical overload damage by fuses. This vehicle has 5 fuse panels, one located in the driver’s side panel bolster, the other in the engine compartment. If any of your vehicle’s lights, accessories, or controls do not work, check the appropriate circuit fuse...