Hyundai Santa Fe: Lighting System / Center Garnish Lamp. Repair procedures

Hyundai Santa Fe (TM) 2019-2024 Service Manual / Body Electrical System / Lighting System / Center Garnish Lamp. Repair procedures

Removal
  
When removing with a flat - tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
Put on gloves to prevent hand injuries.
1.
Disconnect the negative (-) battery terminal.
2.
Remove the rear combination cover (A).

3.
Remove the inside rear combination lamp assembly after loosening the nuts and disconnecting the connector.

4.
Remove the center garnish lamp (A) after loosening mounting nuts.

Installation
1.
Install the center garnish lamp.
2.
Install the inside rear combination lamp.
3.
Connect the negative (-) battery terminal.

    Rear Combination Lamp. Repair procedures

    Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the rear combination lamp mounting cap (A)...

    Auto Lighting Control System

    ..

    Other information:

    Hyundai Santa Fe (TM) 2019-2024 Owner's Manual: System operation


    Operating conditions Smart Cruise Control will operate when the following conditions are satisfied. Basic function The gear is in D (Drive) The driver’s door is closed EPB (Electronic Parking Brake) is not applied Your vehicle speed is within the operating speed range -- 5~110 mph (10~180 km/h): when there is no vehicle in front -- 0~110 mph (0~180 km/h): when there is a vehicle in front ESC (Electronic Stability Control), TCS (Traction Control System) or ABS is on ESC (Electronic Stability Control), TCS (Traction Control System) or ABS is not controlling the vehicle Engine rpm is not in the red zone Forward Collision-Avoidance Assist brake control is not operating Remote Smart Parking Assist brake control is not operating Information At a stop, if there is no vehicle in front of your vehicle, the system will turn on when the brake pedal is depressed...

    Hyundai Santa Fe (TM) 2019-2024 Owner's Manual: Precautions while using the head-up display


    It may sometimes be difficult to read information on the Head-Up Display in the following situations. - The driver is improperly positioned in the driver’s seat - The driver wears polarizing-filter sunglasses - An object is located above the head-up display cover - The vehicle is driven on a wet road - Any improper lighting accessory is installed inside the vehicle, or there is incoming light from outside of the vehicle - The driver wears glasses - The driver wears contact lenses When it is difficult to read the Head- Up Display information, adjust the image height or brightness level from the Settings menu in the infotainment system screen...

    Categories

    Vehicle Identification Number (VIN). Vehicle certification label. Tire specification and pressure label

    Vehicle Identification Number (VIN)

    The vehicle identification number (VIN) is the number used in registering your vehicle and in all legal matters pertaining to its ownership, etc.

    The number is punched on the floor under the passenger seat. To check the number, open the cover.

    read more


     
    Copyright © 2024 www.hsafe4.com