Hyundai Santa Fe (TM): Driver Parking Assistance System / Remote Smart Parking Assist (RSPA). Repair procedures

Removal
ADAS Parking ECU (ADAS_PRK)
1.
Disconnect the negative (-) battery terminal.
2.
Remove the ADAS Parking ECU (ADAS_PRK).
(Refer to Advanced Driver Assistance System (ADAS) - "ADAS Parking ECU (ADAS_PRK)")
Parking/View switch
  
When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
Put on gloves to prevent hand injuries.
  
Take care not to bend or scratch the trim and panels.
1.
Disconnect the negative (-) battery terminal.
2.
Remove the console upper cover (A).

3.
Disconnect the console upper cover connectors (A).

4.
Loosen the mounting screws and remove parking/view Switch (A)

Ultrasonic Sensor
1.
Disconnect the negative (-) battery terminal.
2.
Remove the front/rear bumper.
(Refer to Body - "Front Bumper Cover")
(Refer to Body - "Rear Bumper Cover")
3.
Disconnect the connector from the parking distance warning sensor.
4.
Pull out the sensor (A) by opening the sensor holder out.

Installation
1.
Install in the reverse order of removal.
2.
Connect the cable of Diagnostic tool to the data link connector in driver side crash pad lower panel, and turn on the Diagnostic tool.

    Schematic Diagrams Parking/View Switch Ultrasonic Sensor

    Components and Components Location

    Other information:

    Hyundai Santa Fe (TM) 2019-2023 Service and Repair Manual: Description and operation

    Description and Operation Blcok Diagram    • This system monitors the driving situations through the radar and the camera.

    Hyundai Santa Fe (TM) 2019-2023 Service and Repair Manual: Troubleshooting

    Troubleshooting Diagnosis with Diagnostic tool 1. In the body electrical system, failure can be quickly diagnosed by using the vehicle diagnostic system (Diagnostic tool). The diagnostic system (Diagnostic tool) provides the following information.

    Categories

     
    Copyright © 2025 www.hsafe4.com - 0.0124