Hyundai Santa Fe: Power Door Locks / Power Door Lock Switch. Repair procedures

Hyundai Santa Fe (TM) 2019-2025 Service Manual / Body Electrical System / Power Door Locks / Power Door Lock Switch. Repair procedures

Diagnosis with Diagnostic Tool

In the body electrical system, failure can be quickly diagnosed by using the vehicle diagnostic system.

The diagnostic system provides the following information.

(1)	Fault Code Searching : Checking failure and code number (DTC)

(2)	Data Analysis : Checking the system input/output data state

(3)	Actuation test : Checking the system operation condition

(4)	S/W Management : Controlling other features including system option setting and zero point adjustment

2.	If diagnose the vehicle by diagnostic tool, select "DTC Analysis" and "Vehicle".

3.	If check current status, select the "Data Analysis" and "Car model".

4.	Select the 'ICU' to search the current state of the input/output data.

5.	To forcibly actuate the input value of the module to be checked, select option 'Actuation Test'.

Removal

Driver Power Window Switch

1.	Disconnect the negative (-) battery terminal.

2.	Remove the front door trim. (Refer to Body - "Front Door Trim")

3.	Remove the power window bezzel assembl (A) after loosening the mounting screws.

4.	Remove the power window switch assembly (A) after loosening the mounting screws.

Installation

Driver Power Window Switch

1.	Install the power window switch assembly.

2.	Install the front door trim after connecting the connector.

Power Door Lock Actuators. Repair procedures

Inspection Front Door Lock Module Inspection 1. Remove the front door trim. (Refer to Body - "Front Door Trim") 2...

Power Door Mirrors

Other information:

Hyundai Santa Fe (TM) 2019-2025 Service Manual: License Lamps. Repair procedures

Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the license lamp lens (A) from the panel after loosening a screw. 3. Replace the bulb (B) after removing the license lamp (A)...

Hyundai Santa Fe (TM) 2019-2025 Owner's Manual: System operation

Operating switch Turn Signal switch Blind-Spot View Monitor will turn on and off when the turn signal is turned on and off. Blind-Spot View Monitor Operating conditions When the left or right side turn signal turns on, the image in that direction is displayed on the instrument cluster...