Hyundai Santa Fe: Blind-Spot View Monitor (BVM) / System operation
Operating switch
Turn Signal switch
.png)
Blind-Spot View Monitor will turn on and off when the turn signal is turned on
and off.
Blind-Spot View Monitor
Operating conditions
When the left or right side turn signal turns on, the image in that direction
is displayed on the instrument cluster.
Off conditions
- When the turn signal turns off, the image on the instrument cluster will
turn off.
- When the hazard warning flasher is on, Blind-Spot View Monitor will turn
off, regardless of the turn signal status.
- When other important warning is displayed on the instrument cluster, Blind-Spot
View Monitor may turn off.
Blind-Spot View Monitor displays the rear blind spot area of the vehicle in the
cluster when the turn signal is turned on to help change lanes.
Detecting sensor
[1], [2] : SVM-side view camera (camera located at bottom of the mirror)
Refer to the picture above for the detailed location of the detecting sensors...
When Blind-Spot View Monitor is not working properly, or the cluster display
flickers, or the camera image does not display normally, we recommend that the system
be inspected by an authorized HYUNDAI dealer...
Other information:
Seat belt warning light
This warning light informs the driver that the seat belt is not fastened.
Air bag warning light
This warning light illuminates:
When you turn the ignition switch or the Engine Start/Stop button to
the ON position.
- It illuminates for approximately 3~6 seconds and then goes off...
Removal
•
Be careful not to damage the parts located under the vehicle
(floor under cover, fuel filter, fuel tank and canister) when
raising the vehicle using the lift...
Categories

The armrest is located in the center of the rear seat. Pull the armrest down
from the seatback to use it.
read more