Hyundai Santa Fe: Engine Control System / Manifold Absolute Pressure Sensor (MAPS). Description and operation
Manifold Absolute Pressure Sensor (MAPS) is a speed-density type sensor and
is installed on the surge tank. It senses absolute pressure of the surge tank
and transfers the analog signal proportional to the pressure to the ECM. By
using this signal, the ECM calculates the intake air quantity and engine speed.
The MAPS consists of a piezo-electric element and a hybrid IC amplifying the
element output signal. The element is silicon diaphragm type and adapts pressure
sensitive variable resistor effect of semi-conductor. Because 100% vacuum and
the manifold pressure apply to both sides of the sensor respectively, this sensor
can output analog signal by using the silicon variation proportional to pressure
change.

Inspection
Throttle Position Sensor (TPS)
1.
Connect the diagnostic tool on the Data Link Connector (DLC).
2...
Specification
Pressure (kPa)
Output Voltage (V)
20.0
0.79
46.7
1...
Other information:
Shifting conditions not met. Reduce speed, then shift
The warning message appears on the LCD display, when engine RPM is too high,
or when driving speed is too fast to shift the gear.
We recommend you decrease the engine speed or slow down before shifting the gear...
Checking the brake fluid level
Check the fluid level in the reservoir periodically. The fluid level should be
between MAX and MIN marks on the side of the reservoir.
Before removing the reservoir cap and adding brake fluid, clean the area around
the reservoir cap thoroughly to prevent brake fluid contamination...
Categories
The front seat can be adjusted by using the control switches located on the outside
of the seat cushion. Before driving, adjust the seat to the proper position so that
you can easily control the steering wheel, foot pedals and controls on the instrument
panel.
WARNING
NEVER allow children in the vehicle unattended. The power seats are operable
when the vehicle is turned off.
read more