Hyundai Santa Fe (TM): Brake System / Brake Line. Components and components location
| Components |
Removal [G 2.5 T-GDI THETA III (Only)] 1. Disconnect the batter ( - ) cable. 2. Remove the retaining clip then remove the vacuum pump hose (A).
Removal • Be careful not to damage the parts located under the vehicle (floor under cover, fuel filter, fuel tank and canister) when raising the vehicle using the lift.
Other information:
Hyundai Santa Fe (TM) 2019-2023 Service and Repair Manual: Evaporator Temperature Sensor. Repair procedures
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the evaporator temperature sensor connector. 3. Measure resistance between terminal "+" and "-" of the evaporator temperature sensor.
Hyundai Santa Fe (TM) 2019-2023 Service and Repair Manual: Auto Defogging Sensor. Repair procedures
Inspection To inspect and diagnose the sensor, refer to Self-Diagnosis procedure and DTC guide. Replacement 1. Disconnect the negative (-) battery terminal. 2. Remove the rain sensor inner cover (A) and rain sensor cover (B).
Categories
- Manuals Home
- Hyundai Santa Fe Owners Manual
- Hyundai Santa Fe Service Manual
- Emission Control System
- Rear seats
- Troubleshooting
- New on site
- Most important about car
