Hyundai Santa Fe (TM): ESP(Electronic Stability Program) System / Yaw-rate and G Sensor. Schematic diagrams
| Schematic Diagrams |
Specifications Description Specification Operating voltage 8 - 16V Output signal CAN Interface Operating temperature -40 - 85°C (-40 - 185°F) Yaw-rate sensor Measurement range -128 to +128°/sec Frequency response 15 - 45Hz G sensor Measurement range -1.
Removal 1. Turn ignition switch OFF and disconnect the negative (-) battery cable. • Disconnect the battery negative cable and wait for at least thirty seconds before beginning work.
Other information:
Hyundai Santa Fe (TM) 2019-2023 Service and Repair Manual: Smart Key. Repair procedures
Smart Key Smart Key Code Saving 1. Connect the DLC cable of diagnostic tool to the data link connector (16 pins) in driver side crash pad lower panel, turn the power on diagnostic tool. 2.
Hyundai Santa Fe (TM) 2019-2023 Service and Repair Manual: Rear Occupant Alert
Description and operation Description The system detects the passenger in the vehicle and prevents the driver from getting off the vehicle with the passenger in the back. - 1st warning: If you open the driver's door after you open and then close the rear passenger and turn the engine off, the system provides warn
Categories
- Manuals Home
- Hyundai Santa Fe Owners Manual
- Hyundai Santa Fe Service Manual
- Heating,Ventilation And Air Conditioning
- Troubleshooting
- Emission Control System
- New on site
- Most important about car
