Hyundai Santa Fe: Seat Electrical / Walk-in Switch. Repair procedures

Hyundai Santa Fe (TM) 2019-2025 Service Manual / Body Electrical System / Seat Electrical / Walk-in Switch. Repair procedures

Removal

Actuator

1.	Remove the rear seat. (Body - "Rear Seat Assembly")

2.	Disconnect the walk in actuator connector and then remove the actuator.

3.	Remove the cable (A) and then separate the walk in actuator.

Upper Walk in Swtich

1.	Remove the rear seat walk in switch (A).

2.	Remove the walk in switch by using a flat-head screwdriver and then disconnect the walk in switch connector (A).

Lower Walk in Switch

1.	Loosen the screw and then remove the rear seat recliner knob (A).

2.	Loosen the screw and then remove the rear seat recliner cover (A).

3.	Remove the walk in swtich (A) after loosening the connector.

Luggage

1.	Remove the luggage side trim. (Refer to Body - "Luggage Side Trim")

2.	Remove the luggage remote folding switch (A).

Walk-in Switch. Schematic diagrams

Fuel Filler Door

Other information:

Hyundai Santa Fe (TM) 2019-2025 Owner's Manual: EPB malfunction

Electronic Parking Brake (EPB) warning light illuminates if the Engine Start/Stop button is pressed to the ON position and goes off in approximately 3 seconds if the system is operating normally. If the EPB warning light remains on, comes on while driving, or does not come on when the Engine Start/Stop button is pressed to the ON position, this indicates that the EPB may have malfunctioned...

Hyundai Santa Fe (TM) 2019-2025 Service Manual: Special service tools

Special Service Tools Tool(Number and Name) Illustration Use Deployment tool 0957A-34100A Airbag deployment tool. Use with (0957A-AL140, 0957A-AL160) Dummy 0957A-38200 Simulator to check the resistanceof each wiring harness...