Hyundai Santa Fe (TM): Body Electrical System / Fuel Filler Door

Components and components location

Component Location

1. Fuel filler door release actuator

Fuel Filler Door Release Actuator. Repair procedures

Removal
1.
Remove the left luggage side trim.
(Refer to Body - "Luggage Side Trim")
2.
Disconnect the connector (A) and then remove the release actuator (B).

3.
Disconnect the cable (A) and then remove the release actuator.

4.
Check for continuity between terminal No. 1 and No. 2. If there is no continuity, replace the fuel filler door release actuator (A).

    Components and components location Component Location 1. Lumber support motor (Vertical) 2. Lumbar support motor (Horizontal) 3.

    Components and components location Component Location 1. Engine room relay box 2. Sub relay box 3.

    Other information:

    Hyundai Santa Fe (TM) 2019-2023 Service and Repair Manual: Compressor. Repair procedures

    Removal 1. If a compressor is available, the air conditioner is operated for a few minutes in the engine idle state and then the engine is stopped. 2. Disconnect the negative (-) battery terminal.

    Hyundai Santa Fe (TM) 2019-2023 Service and Repair Manual: Heater

    Heater Unit. Components and components location Component Location 1. Heater Unit Assembly Components 1. Heater unit assembly 2. Heater NVH pad 3. Heater seal duct 4.

    Categories

     
    Copyright В© 2026 www.hsafe4.com - 0.0277