Hyundai Santa Fe (TM): Lighting System / Turn Signal Lamp. Repair procedures

Hyundai Santa Fe (TM) 2019-2023 Service and Repair Manual / Body Electrical System / Lighting System / Turn Signal Lamp. Repair procedures

Removal
Outside Rear View Mirror
  
•
Put on gloves to prevent hand injuries.
•
When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
1.
Disconnect the negative (-) battery terminal.
2.
Remove the front door trim.
(Refer to Body - "Front Door Trim")
3.
Disconnect the rear view mirror connector (A).
4.
Remove the rear view mirror cap (A).
5.
Loosen the mounting nuts and then remove the outside rear view mirror (A).
6.
Remove mirror (A) to the direction as shown in the picture using (-) screw driver.

7.
Remove the mirror cover.
8.
Loosen the outside rear view mirror mounting screw.
9.
Remove the side repeater lamp
Front Turn Signal Lamp
1.
Disconnect the negative (-) battery terminal.
2.
Remove the turn signal lamp after turning in the counterclockwise direction.
Rear Turn Signal Lamp
1.
Disconnect the negative (-) battery terminal.
2.
Remove the rear bumper.
(Refer to Body - "Rear Bumper Cover")
3.
Loosent the mounting screw and then remove the rear turn signal lamp.
4.
Remove the bulb after turning in the counterclockwise direction.
Installation
Outside Rear View Mirror Turn Signal Lamp
1.
Install the side repeater lamp.
2.
Install the mirror cover.
3.
Install the mirror.
4.
Connect the negative (-) battery terminal.
Front/Rear Turn Signal Lamp
1.
Install the front/rear turn signal lamp.
2.
Install the front/rear bumper cover.
3.
Connect the negative (-) battery terminal.

    Removal    Head lamps become very hot during use; do not touch them or any attaching hardware immediately after they have been turned off.

    Inspection 1. Remove the room lamp assembly then check for continuity between terminals. Removal 1.

    Other information:

    Hyundai Santa Fe (TM) 2019-2023 Service and Repair Manual: Lane Safety Button. Repair procedures

    Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower pannel. (Refer to Body - "Crash Pad Lower Panel") 3. Loosen the mounting screw and remove the crash pad garnish [LH] (A).

    Hyundai Santa Fe (TM) 2019-2023 Service and Repair Manual: Surround View Monitor (SVM) Camera. Components and components location

    Categories

     
    Copyright © 2025 www.hsafe4.com - 0.0187